Programming Tynetec XT1 Wireless Devices

This guide relates to all XT1 wireless devices such as pendants, pull cords, smoke detectors and fall detectors. 

Adding Wireless Devices

Via the handset

This programming must be carried out by the site manager, or someone with access to the systems phone.

Note: this must be carried out in, or in close proximity of the site office.

 

1.  Pick up your warden call handset and wait for the “Ready” prompt in the earpiece

2. Enter the code 5000*

3. Enter the flat number followed by the * key

4. Activate the pendant (or other 169MHz radio device) to be added

5. When prompted for a location code, press the # key.

6. Wait for the “Radio Device Enabled - Enter Flat” prompt

7. Repeat from step 4 above to add more radio devices or press # key to exit the mode

8. Press the LINE key to clear the connection.

9. Once in the flat, press the pendant firmly to start a test call. Ensure that the details presented on the managers phone are correct.

 

 

Removing Wireless Devices

Via the handset

This programming must be carried out by the site manager, or someone with access to the systems phone.

Note: this must be carried out in, or in close proximity of the site office.

 

1.  Pick up your warden call handset and wait for the “Ready” prompt in the earpiece

2. Enter the code 5001*

3. Enter the flat number followed by the * key

4. Activate the pendant (or other 169MHz radio device) to be added

5. When prompted for a location code, press the # key.

6. Wait for the “Radio Device Enabled - Enter Flat” prompt

7. Repeat from step 4 above to add more radio devices or press # key to exit the mode

8. Press the LINE key to clear the connection.

9. Once in the flat, press the pendant firmly to start a test call. Ensure that the details presented on the managers phone are correct.